why 4 to 20 ma ,why not 0 to 20 or 3 to 15 or anything
- 19 Answers
- 42973 Views
- Honeywell, TCS, TN, I also Faced
- E-Mail Answers
Answer Posted / suresh
why put 4-20ma na process zero or live zero.
| Is This Answer Correct ? | 1 Yes | 2 No |
Post New Answer View All Answers
What are the types of valves?
How to Calibrate Interface Level Troll in field
How u will setup SPI(2007) on Citrix Server (Thin Client Mode)? Plz Justify?
What is the principle of capacitance type level transmitter?
Sir , i have completed my M.Sc In Instrumentation and presently working in Maintenance department 3 yrs Exp , is there is any possible for work in offshore ..
what is function of SCADA , and how is it work, explain with difination
I want measure the volumetric flow of gas in waste heat recovery Boiler?Tell me how and which type of instruments required. Plz mail me:naba02222@gmail.com Sam please post the answer .
What is Alpha & Beta fctors related to Orifice Plate & its relation with flow?
2. What is ultrasonic flowmeter?
how many type conductivity sensor ?
PT RTD Range: -200 to 500 degree celsius If I configured in DCS Lower range and Upper range . In face plate it shows red colour due to overa range how was the characteristics look If the temperature is more than operating range. how was the characteristics look . whether its in Resistance vs Temperature curve is Linear or Non linear
selection criteria of control valve? and selection criteria of actuator explain in brief?
what are the selections available in configuring a burnout protection of a controller? thanks
I have 0.75mm sq multicore cable (IS type) , can use instead of same type but 1.5 sq mm cable ? Note : The distance is around about 150 meter.
how to calibrate mass flow meter (Coriolis)? Example calibration range: 0 to 2500 kg/hr line size 3" fluid: Etheline glycol (MEG)
