I am an electrical power engineer and arranged power system
for a data center, I installed MCB, ELCB and erthing system
TN-C-S.
But some times several ELCBs Disconnect circuits at the
same time! what may be the reason? (the ELCBs are 25A ,30mA)
Answer Posted / k.p.sharma
Mr.chandra & mehndi is right and the normally mA of ELCB
used IS AS BELOW:-
1. FOR DOMESTIC = 30MA
2. FOR COMMERCIAL BUILDINGS ETC = 100MA
3. FOR INDUSTRIES = 300MA
Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
Two liquids hot and cold in two vessels are there and an metal bar acts as a conductor of heat between the two vessels. what happens then. what happens after 24 hrs?
How phase displacement change in the over current relay coils.
defination of controlled shunt reactor
Maintenance of transformer???
What will happened if the neutral of secondary of Xformer ( Star point) Note it's above KVA rated Xformer
What is pole of the system?
WHAT HAPPENED DC SERIES MOTOR FIELD WINDING OPEN. CAN POSSIBLE.
How does a transformer contribute towards the widespread popularity of ac system over dc?
how to electronic energy metter failed in electomagnectic fild passing in the metter and which thing to defect more on metter.
condition Autotrip facia come on control panel of electrical transmission line?
in the directional overcurrent and earthfault protection,normally we are setting the angle 45 deg lead for phase fault overcurrent and -45 deg lead for earthfault fro forward direction.but both the fault are operating on the same angle region only.why?how the relay will response?
What is the method of estamating of cable, CB,MCB ?
how to calculate the settings for shaft ct protn in hydro generators
Why is tan-delta test and capacitor measurement done on alternator?
If 24 KVA AVR having Input voltage 200-400v, Output voltage 415+-1%, what will be the voltage if Load is 13A.