Interested to Buy Any Domain ? << Click Here >> for more details...
what is the minimum dielectric stregth of transformer oil.
- 25 Answers
- 72531 Views
- HP, I also Faced
- E-Mail Answers
Answer Posted / suresh
normally the testing kit is available for 2.5 mm airgap it
required 50 KV means lcm 200kv BDV value is required.
| Is This Answer Correct ? | 7 Yes | 9 No |
Post New Answer View All Answers
can mini-curcuit supply MIL-tested transformer !
How to select a contactor? How many types of contactors are available
the site measured knee point voltage of protection class CTs should be greater than rated knee point voltage? what about meetering class CTs. Should it be below the rated knee point voltage?
What is the function of interposing current transformer?
How can I calculate per unit (KWH) fuel (Gas/ Diesel both) consumption 1MW unit?
What is a Phase shift meter? Where can I get one?
what is the safe meggar values for motor, transformer HT, LT and Cables? IF we want to replace I/C bay at our 220 kv substation which is of 140 mw load capacity bay to be replaced by 400 mw capacity bay.other than CT(1200/1) what are the other equipment i have to replace. why we generally use 3.5 core cable or in other word 1/2 core for neutral and also confirm me that in balance conditiob(3 phase)current in neutral will zero
what is meant by skew width in machines?
What is the effect on Power factor and capacitor when your company load is more than 70 % of welding transformer
What are the components connected in between the power supply coming from an electric pole to HT & LT Panels in a large commercial building or how the power supply connected from Electric pole to Transformer & then to the HT & LT panels of a building? Please send me answers via mail, my id is yogiagarwal@gmail.com. If possible, please give a line diagram.
What cmos is and its benefits?
circuit diagram of trip circuit supervision relay
application s to shunt coil
Anybody tell me about modbus hex address of l&t trivector meter er300p??I want to read voltage,current,kwh etc via rs485...If anybody have a manual then send on my mail..Brijeshmodi18@gmail.Com
In between UPS out going changer over switch and ups raising main input, both side cable gland producing heat but the cable doesn't get heat,Why?
