Interested to Buy Any Domain ? << Click Here >> for more details...
in the pipe line if the control valve fails to respond to
controller action,by what means we can stop the flow in the
pipe line ?
- 9 Answers
- 11615 Views
- I also Faced
- E-Mail Answers
Answer Posted / renjith
For every control valve there will be option to manually
close the valve by adjusting a screw.
| Is This Answer Correct ? | 11 Yes | 1 No |
Post New Answer View All Answers
We Have Two Field bus Pressure Transmitters of Different Sensor Range (I.E One is of Lower range and Another is of Higher Range).Is same Process Line. My Question is Can i provide Saturation Limit to my field Bus Transmitter as We can provide Saturation current limit to HART Instruments. As During Low Pressure Both Working OK ,But During High Pressure, transmitter with Lower sensor range Goes to Fault mode as Beyond its Sensor Limit it can Measure, So may I provide Saturation point Some where to Suppress This Fault during High Pressure.
If a control valve is hunting means means if we are giving 50% to the cv, the cv will open at 51% then slowly slwoly it will reaches 49% , so what to do for solve this problem. The cv is double acting and mounted for anti surge operation, it having 4 nos. volume booster, one sov, one positioner, etc..?
Decibel.
How to calibrate smoke Dectector
What is the meaning of wet leg
how to check earthing,what is minum ohms for proper earthing
what is function of sensor, and how is it work , explain with difination
Which type of pressure can be measured by these elements?
how to calibrate corollaries (Mass flow meter)?
how to calibrate steam control valve in steam turbine
What is the basic difference between Modbus and CAN Open Protocols
my data card only does run in my mobile so how can change it that it run other mobile & computer and i can stor data in my data card
What is the use of control cable?
How do you identify an orifice in the pipeline?
what is the calibration procedure for magnetic flow meter @ onsite
