Interested to Buy Any Domain ? << Click Here >> for more details...
what is diff between sensors and transducers.explain with
ex?
- 15 Answers
- 45409 Views
- I also Faced
- E-Mail Answers
Answer Posted / jagan p
Sensor senses the measured quantity and convert into a
signal whereas transducer converts one form of energy into
another.All Sensors can be a transducers but all transducer
can't be a sensors.Transducer needs a sensor to display the
output.
| Is This Answer Correct ? | 7 Yes | 13 No |
Post New Answer View All Answers
What are the application of bernoulli’s theorem?
our kks tagging is crossing more than 12 character please suggest how to take tags in the DCS
How u measure the massflow in orifice flow measurement techniques
what are the different types of Protocols? & their applications.
How to calibrate Field bus transmitter? procedure ?
A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.
What is hp & mp seperator .& what is its working principle ?
What denotes the 5/8mm in the 3300XL 5/8mm proximitor probe?
Explain the difference between mmwc and mmwg?
while i check zero check for dp flow transmitter some fluctuating came (0 to 458 kg/h) what is the reason?
it is possible to check the fail safe condition in pressure transmitter. if possible how?
how to convert MA in to measuring values..and how mwasuring values into MA ?..plz ansr.i have intervw
What is the procedure of calibration of Load cell?
how does we calibrate a square root flow transmitter ,give an example and explain it step by step like range calculation , calibration hook up series connection , zero check , and how to apply pressure , and if not geting proportional output then what should we do ?
Any body have know try work calculation ???
