Answer Posted / a.bala
L.T=Low tension
Upto 60 HP to be consider as LT ( 60 hp in Tamilnadu and
80 hp in gujarath )
| Is This Answer Correct ? | 1 Yes | 4 No |
Post New Answer View All Answers
while doing high voltage test on 11kv/433 distribution transformer why we only give 28 kv on hv side and 3kv on lv side for power transformers what is the value what factors it depends
please explain to me how to calculate current,voltage,resistance with formula??
Why star delta starter is preferred with induction motor?
How to select batteries required for ups and the inverter if we Known load? And how AH is selected of battery?
what is the diference between the 4pole & 6pole DC Motors & what is advantage 6pole over the 4pole ?
what is negative and zero impedance in 3 phase induction motor ??
what is ramping rate of generator
describe the fully control circuit diagram of ac drives
If anyone would like to know or practice for FEWA papers contact me on mohamedrashad2@hotmail.com Just completed the supervisor exam in April 2021
In single phase ac ups supply when current is measured with tong tester neutral current is found more than phase current.What is the reason?
what are the different kind of cables used for transmissions?
How to test Alternator stability test for REF relay
When calculating the speed of a rotor required for a particular frequency of synchronous generator we use the equation 60f/p Is this p is the number of pole pairs of rotor & do we consider the number of pole pairs in the stator is 1?
application s to shunt coil
where was current transformer protection units used and why??
