how to install Differential pressure transmitter in gas
line.i need transmitter down side.
- 7 Answers
- 22125 Views
- Rockwell, I also Faced
- E-Mail Answers
Answer Posted / snehal
place the taps side of the line
place the transmitter beside/above the line so that
condensed fluid will drain off
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
where i can get training in INTOOLS and PDMS in Delhi-NCR OR north part of India. please reply with ur ans. at arunsamkaria@ymail.com
what is the working principal of pribe
how many types of spped sensors n vibration sensors?their basic principle n connection?
How many types of sensor
What is cut off relay? And why use in PLC and DCS?
I want to measure and control level in tank of size 10*5 filled with gasoline, so plz give me the solution with clear details. how to select transmitter and sensors.
(1) In turbine, what does term CDP, NI, NH, HSSOC, means. (2) What is the purpose of LO overhead tank in turbines.(3) An equipment is certified for EEX, IA, IIC,T6, what do you under stand by this.(4) what is SURGE, and how it is prevented, what is the purpose of bypass valve across AS valve.(5) Give 2 application of quartz crystal used for process parameter measurement.(6) what is meant by cold float of compressor shaft. (7) state four different types of flow measurement. For gas flow measurement mmscfd is the common unit. Expand the unit and specify significance of word S in the unit.(8) what is meant by Gap voltage, in vibration measurement. Normally how much Gap voltage is set and state the reason.(9) what will the new flow factor if D/P transmitter is Re-Ranged from 25” wc to 50” wc.(10) what is the usage of QDV & Volume booster.
Instrumentation symbols interpration, P& ID, Logic diagram analysis, Electrical drawing analysis.
Decibel.
how radio frequency level probes works with its controller ? what is its principle ? pls give me brief explanation?
What is difference between differential pressure & delta pressure?
How we connect a instrument with ground, Give brief explanation with help of diagram?
What is the use of gauge?
i want to find out iffco get test paper
In Safe Guarding test what means by "Failed to Danger" ?
