At site, we have 30Kw motor (3 phase, 400V,50Hz) and FLC
54A as per the nameplate. At the time of starting it draws
840A instead of 390A (7.2%). As per the data sheet also its
390A starting current. it thru a dol starter from the MCC.
can anyone tell what is the problem in the motor
Answer Posted / atul pradhan
pl. check motors connection in terminal box if it is
connected in star then current may increased.
Is This Answer Correct ? | 5 Yes | 13 No |
Post New Answer View All Answers
what is the difference between b c d curves on mcb
Why an ac solenoid valve attract the plunger even though we interchanges the terminal? Will the poles changes?
what's prime importance of protection in electrical system.if protection system don't work properly what can happen in electrical system?
why genarator genarating voltage 11 KV?
how to size H.T & L.T Panel ?
A system absorbs 100 k J of heat and the increase in its internal energy is 100 kJ; the work done is
Q.1:What protection will be used on HT and LT side of 33/0.4 KV, MVA transformer. Indicate capacities of protective device to be used. Q.2:Which types of back-up protections are used in the power transformers? What do you understand by the term over travel in the relay? Q.3:How star and delta connected winding transformer are provided from earth fault
what is smart grid? why we use it? explain in detals bcoz i want give presentatin from it....
What are the main advantages of bode plot?
how to calculate kvar in Akiva
What is the minimum distance to be maintained in between HT panel and LT panel and Instrument panel as per IEC and NEC standards?
What do you mean by an instrument transformer?
Does all the output contacts (N/O as well as N/C) of a Numerical relay operate when relay receives a binary input/inputs or contacts are designated to specific logic input/inputs and only these contacts operate?
WHY MOSTLY Rph IS USED FOR CONTROL CIRCUITS AUX. SUPPLY ?
Can we use shunt trip coil instead of trip coil with protection relay for protection?