Interested to Buy Any Domain ? << Click Here >> for more details...
what is the difference between ac and dc generator
- 14 Answers
- 41918 Views
- I also Faced
- E-Mail Answers
Answer Posted / fireprs
All the Generators produce ac currents(in accordance with
Faraday's Law).
In DC generator the generated ac voltage is converted into
DC through commutator,while in ac gen. ac voltage is
supplied.
| Is This Answer Correct ? | 41 Yes | 16 No |
Post New Answer View All Answers
why we use copper earthing for neutral while for body GI.
is it possible to test of bus bar in high rise building without completed full floor ?
The power supplied to a 33microF capacitor from a 120V, 60Hz source will be
can I improve the furnace power factor (10 mva transformer) by adding a capacitor bank before the transformer.Does system power factor vary a lot with the furnace PF?
it is in our knowledge tht right plug of supply of residential suppy system is phase n other is neutral...howevr the battery charger of mobile works in both ways...i mean it is not restricted in only one direction.ny of the holder of charger can hav phase .so y is it not lik tht phase of supply must b connected 2 phase of charger...?
WHERE CAN I GET THE PREVIOUS QUESTION PAPERS OF Govt Polytechnic in deee 2nd year papers
Suppose a 3 phase, 2 pole, 440V induction motor is driving a flywheel of 600mm diameter, 150kg mass. By using v-belt and pulley, the speed is increased to 4500 RPM. What will be the effect on motor current?
WHY TERTIARY OF POWER TRANSFORMERS IS LOADED WITH EQUIPMENTS LIKE CT,PT,ISOLATOR AND CB
at meter room 50 hrc switch installed,but there are not get earthing proper,so what happen?and 11kv transformer out put going in to hrc main 400a three nog each? so earthing is require for all switch? (some customer made earthing at there home.)
whati s the sludge current in ups
what are the available sizes of pin type terminal lugs in the market today?
any body,pls tell me how to done relay coordination ? how to coordinate by TCC curve?how to read the tcc curve?
What is pole of the system?
What kinds of decision are made about CT from it's Knee point(voltage & current)?
How to calculate no of Lighning arrestors are required for protecting 50mX 50m*20m cubical building and locations of LA?
