Interested to Buy Any Domain ? << Click Here >> for more details...
We have 2 no. 4MW DG set. and GEB supply.
But, we running, only 1 DG set. when we done APFC/Power
factor setting : 0.90, then winding temp. Low. but when
setting done : 0.83, then Winding temp. increase.
WHY Why ? ? ?, plz give me answer.
- 4 Answers
- 7459 Views
- I also Faced
- E-Mail Answers
Answer Posted / sudheer
i think the main reason is load. when the power factor is
0.90 then the generator run smoothly and not over loaded.
| Is This Answer Correct ? | 2 Yes | 1 No |
Post New Answer View All Answers
what is (+) and (-) in generator field detector stand for?
How to Preparation of online test
can any one tell in easy method for circulating current ??
r we are using in gas turbine mark (5) frame (6) (made in india Bhel 1997) Ā
difine electrical ballast in HPSVL
What is the RME and explain the full form and what is the RME work?
give single line diagram of D.G distribution form alternator to main L.T panel?
What is the rating of a circuit breaker needed for 300 kv load in 33KV supply line of 33/415 transformer ? Whether 800/1200 amp vaccum circuit breaker can perform for a 33 KV line in input in 415 volt in output of the transformer ?
transformer spections :: input voltage 0-110-230v; output volage 0-10-12-14v; amp=3A using CRNO CORE, capcaity=50VA primary turns = ? ; secondry turns =?
salam&hi, i need to know about how can i calculate an enough current for the new building before i submit it to the suppliers
write circuit diagram for a motor rotate in forward direction once it started and when pressed the same button it should rotate in anticlockwise.
Explain the working of any one cutting machine
Can you explain about Restricited earth fault protection scheme
iam working in power plant. In hot places tube lights are glowing at the end portion only. what is the reason for that?
A cylindrical wire is compressed in length by 10%. The percentage decrease in the resistance will be?????
