Interested to Buy Any Domain ? << Click Here >> for more details...
what is dead weight tester and where it is used?.
- 11 Answers
- 21999 Views
- DuPont, Jain steels, I also Faced
- E-Mail Answers
Answer Posted / xxx
Dead wt tester is a caliberation gauge wherein you balance d
pressure due to known wt wit tat of ur unknwn pr gauge...
| Is This Answer Correct ? | 1 Yes | 1 No |
Post New Answer View All Answers
What is the use of each wire in three wire RTD
In control valve proximity inductive sensor is taken as digital feedback for full open and full close.Normally its volts 24v when the sensor acts the feed back voltage 14v so that our relay not indicating in plc panel . kindly give the solution.
How u will setup SPI(2007) on Citrix Server (Thin Client Mode)? Plz Justify?
how does we calibrate a square root flow transmitter ,give an example and explain it step by step like range calculation , calibration hook up series connection , zero check , and how to apply pressure , and if not geting proportional output then what should we do ?
how to calibrate steam control valve in steam turbine
WHAT IS TMXT IN TEMPERATURE FOUNDATION FIELDBUS.
What is the start up procedure of desalter
A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.
types of cable..? Use of every types of cable..?
what is easiest way to read STL language in PLC?
what is the difference between profibus and controlnet networking.
Explain the use of hair spring in the pressure gauge.
how many types of viberation transmitter and how to calibrate and where use of vibration transmitter
In power plant to measure vibration of a turbine we install sensors. Before install this sensor we have to set gap voltage. What is meant by gap voltage and its use?
what is wave length were using ?
