Interested to Buy Any Domain ? << Click Here >> for more details...
what is dead weight tester and where it is used?.
- 11 Answers
- 21773 Views
- DuPont, Jain steels, I also Faced
- E-Mail Answers
Answer Posted / praveen kumar
Dead Weight Tester is Master calibration equipment for
calibration of Low & High pressure ranges, Instruments i.e
Transmitters,Switches, Gauges also.
| Is This Answer Correct ? | 10 Yes | 0 No |
Post New Answer View All Answers
What is the use of double seated valve?
what are the definitions of input, output, command & signal according to instruments controlled by PLC using DCS System?
need to calculate flow rate with the help of dp range and orifice bore dia and size. range is 0 to 400 inwc and orifice size is 12 inch 150 # rf and bore dia is 7.180 inch. need to calculation for flow rate
I want to apply for the universities in US,but i got the GRE score of (650+300=950)TOEFL 69/120.Is this score sufficient for applying universities please i am married i need to go to US because my husband didn't get H1 yet.please send me suggestion
how u calibrate pneumatic n motorized c/v?
how is work pressure switch& level switch?what is the principle of this?
how to change measuring units from mmwc to cubm/h in rosemount air flow transmitter with hart communicator fluke 744
What are the uses of orifice plates?
How u will setup SPI(2007) on Citrix Server (Thin Client Mode)? Plz Justify?
What should be the main consideration while starting the Rotating compressor when we dont know the cut in and the cut off pressure setting of the pressure switch
Please asked me How calculate DCS controller memory.
Explain plc level and its type?
PT RTD Range: -200 to 500 degree celsius If I configured in DCS Lower range and Upper range . In face plate it shows red colour due to overa range how was the characteristics look If the temperature is more than operating range. how was the characteristics look . whether its in Resistance vs Temperature curve is Linear or Non linear
How can test or measure the probe and extension cable to identify if the problem at the probe or cable or at the driver it self? (pleast notify the measuring method)
How to calibrate Toxic gas detector?
