Interested to Buy Any Domain ? << Click Here >> for more details...
What core magnetic balance test of transformer?
How to do this test in a three phase Star delta (star-LV,
Delta-HV) transformer?
How to measure and where to measure?
thanks and regards
Austin
- 22 Answers
- 101795 Views
- Neutech, Power Grid, TSSPDCL, I also Faced
- E-Mail Answers
Answer Posted / engr. l.o. osuji
Hi,
You may use either single-pase on the star side of the
transformer as in Answer #2 or apply two line voltages i.e.
apply 415V on A and B terminals on the HV-side of the
transformer and follow the steps of Rajukumar Sripelli in
Answer #5.
| Is This Answer Correct ? | 6 Yes | 4 No |
Post New Answer View All Answers
how to check regenerative load in drived motor
What is online and offline ups? how does it works?
What should be the amps for a MV fuses for transformer 630kVA 20(10)/0.4 kV
How to measure the Harmonic Distortion of UPS ie THD?
what is the calculation method to design core and winding of a 200kva 3phase distribution transformer?
What is dielectric loss?
all details of DG UPS HVAC
what is high and low cut off voltage of BB and DG at SPS????????
Ratings of power transformer,Distribution transformer.
What is the emf equation of a transformer?
HOW TO CALCULATE CAPACITOR BANK OR HARMONIC FILTER CALCULATION
WHY IS THE EARTH FAULT CURRENT ALWAYS LESS THAN THE NORMAL CURRENT??
Y phase plates are used in transmission line??? what is there need???
Define damping ratio.
As per standard, transformer body earthing and other Equipment earthing (Equipment earthing) did not connect. but in LT side termination we are doing metal glanding in both side Transformer to PCC Panel through armoured cable, now X'mer body earthing and PCC Pane earthing (Equipment earthing) both are connect.is this safe for X'mer or other equipment?
