Interested to Buy Any Domain ? << Click Here >> for more details...
if only one generator is running in droop mode parrallel
with grid and suddenly grid breaker off what will happen?
It will trip o/u freq or stay as it is? (urgent)
- 10 Answers
- 15176 Views
- I also Faced
- E-Mail Answers
Answer Posted / atul pradhan
Paralelling with grid mean your DG is running on stand by
mode or droop mode, your systems load is on grid. when grid
trips all load shifted on DG WITHOUT INTERRUPTION when grid
power comes check synchro. relay gives command again to DG
& it will again run on droop mode.
| Is This Answer Correct ? | 1 Yes | 6 No |
Post New Answer View All Answers
hi friends ,iam working as genset AVR service engineer in electrical field from past 2 yrs throughout india . i plan to shift in some other job without travelling in same field because i con't travel,i dont know what i do for that so please guide me what job is suited for me,how i can serch the job please anybody helpme iam totally confused
Battery is a voltage source? give one example of current source and why?
what is different between phase and netural
SUTIABLE FOR ohm's law super conductor
Explain in details how you would react to an unexpected incident when your supervisor or manager is not around to give instructions?
orifice sizing how done, checking & selection
are there rmu for 3 transformer?
How the capacitance og capacitor volatage transformer is decided?
Types of test in Switchgears, MCC, NGR and DB's how it should be procced. Can anyone give me the details here or email me to pasuvaraj.k@gmail.com
what are the things that can cause a three phase motor to crawl?
Pls explan the OLR setting in VCB at HT yard
in cvt,there are two windings,1a,1n and 2a,2n.in my one project i use only one winding i.e.1a,1n. the other winding is not in use, so i connect it in open delta and want to close it by ibsertibg thermal resistor. the output of cvt is 132kv/115/sqrt3. plesae tell me exact value of resistor, so i may close it to avoid the resonance phenomenin. send me answer on this email adress please. aetcon-po@aetcon.com
why do you add the load short circuit impedance when considering short circuit amperage. It seems that you should only consider supply. If you need to consider loads and you don't know what loads are to be added , what would be a good sub-transient reactance rating for the loads?
STATE USE OF ARC RUNNERS & SPLITTERS ?
what is Fan Control Cubicle
