WHAT IS THE THUMBRULE FOR FINDING OUT THE CURRENT CAPICITY
OF A COPPER WIRE?? 2.5, 4, 6MM SQUARE ETC...
- 5 Answers
- 11581 Views
- I also Faced
- E-Mail Answers
Answer Posted / uttam dutta
cURRENT CARRYING CAPACITY NOT ONLY DEPENDS ON THE CROSS
SECTION OF THE COPPER WIRE, IT ALSO GREATLY DEPENDS UPON
THE TYPE AND THICKNESS OF THE INSULATION, ONE MORE FACTOR
IS CORE OF THE CABLE, IE SINGLE CORE OR MULTICORE.
cONSIDERING ALL THIS FATORS STRICTLY IT CAN BE SAID 1 SQ.
MM COPPER CABLE CAN BEAR MAX.11 AMP SAFELY CONTENIOULY AND
2.R CAN BEAR 19 AMP . 4 SQ MM CAN BEAR 26 AMP. SOME TIME
THIS MAY VARY LITTLE DEPENDING UPON MAKE.
| Is This Answer Correct ? | 7 Yes | 4 No |
Post New Answer View All Answers
can someone explain that how the speed of the protection system affects the fault level calculation?
which mm cable should be used for 1.hp immersible pump motor for the distance of 330 metres?
Could the power factor on electrical system can affect the registration of the kwhr meter or the CT/PT?
In case of salient pole alternator when number of poles are 4 or more than 4 it helps the flux wave to be sinusoid as air gap length is increased from center to tip , but if the number of poles are 2 how does the flux wave is sinusoidal?
derive DC RMS value for half wave rectifier?
if any body have question paper of railway (section engineering),then plz send me .i will thank of him/her.
what will happen if the prime mover on the field excitation of the on-coming generator fails?Explain.
Whether 3 phase induction motorwith 100 hp capacity , Amp 160 for which sensitive earth fault relay , type CTUM 15 can be used?
Can Anyone Answer anyone of these ? Q1) why direct SOLUTION of Load Flow Studies in Not Possile ? Q2)Why majority of Buses in power system are load buses Q3)Why one of the buses in Power system is taken as reference bus (slack or swing) Bus ? Q4)Bus Admittance Matrix is a sparce (means it contains some zero elements ) matrix , give reason
please give me all the Alarm .Trip ,Safety Relays & Conditions of UPS Systems mail me on ashokbabunhce@gmail.com
The Q-facr o of a coil given as wL/R. what will be shape of Q versus frequency graph.
Is it required to use Automatic transfer Switch in L&T panel board if we use AMF panel with DG set? How the single line diagram will be? Please forward the material to sreenu_207@yahoo.co.in
What are the raitings of Mcb,mccb and Acb in detail ??
i need previous entrence exam papers of nhpc.
what is the advantages of having in-built acvvvf (without seperate inverter in the control panel)in the drive system of elevators?
