is there any difference between protection C.T and
measuring C.T?if yes then what is the difference?
- 4 Answers
- 11018 Views
- BARC, Century Rayon, I also Faced
- E-Mail Answers
Answer Posted / suneetha
ct used for protection has to carry full load current and
fault current.ct core shudnt get saturated while carryin
fault current.So the ct used for protection shud hav high
saturation factor.But ct used for measuring shud hav high
accuracy
| Is This Answer Correct ? | 17 Yes | 4 No |
Post New Answer View All Answers
How it can worked plc based electrical system And which type of software using.
What are high pass filter and low pass filter? and What are the flowmeter ?
IF I KNOW THE AREA OF CROSS SECTION OFTHE WIRE , WATTAGE OF THE LOAD ,VOLTAGE SUPPLY WHAT IM GIVING TO THE LOAD AND ALSO POWER FACTOR OF LOAD ....... SO GIVE ME FOR WHAT AMOUNT OF CURRENT I SHOULD USE WHICH TYPE OF CABLE?
Draw the circuit of clapp oscillator?
What is genrally the % Impedance of a Dg set? How can we calculate Earthing conductor size for a DG set?
what is ground fault in ACB?
Difference between earthing & grounding.?
What is s-domain and its significance?
advantage and disadvantage of team work?
What Should be the value of Vector Surge angle at Tripping and how to calculate it?
Why arc quenching is used in Diode ?
in cvt,there are two windings,1a,1n and 2a,2n.in my one project i use only one winding i.e.1a,1n. the other winding is not in use, so i connect it in open delta and want to close it by ibsertibg thermal resistor. the output of cvt is 132kv/115/sqrt3. plesae tell me exact value of resistor, so i may close it to avoid the resonance phenomenin. send me answer on this email adress please. aetcon-po@aetcon.com
Why is negative feedback invariably preferred in closed loop system?
how to copy from plc ge fanuc versamax series,all input and output, adress, and printout.
where rlc series ckt used?
