what is dead weight tester and where it is used?.
- 11 Answers
- 22531 Views
- DuPont, Jain steels, I also Faced
- E-Mail Answers
Answer Posted / x y z
Dead weight tester is the test instruments, in which the
required test instruments is checked aganinst the standard
weight. And it is used to cablibrate pressure gaure and
PRV.
| Is This Answer Correct ? | 8 Yes | 4 No |
Post New Answer View All Answers
Question on maha cement
Can any body help to get Rsemulator 5000 free from internet if possible then give me any link or any help .
What are the key features of a Distributed Control System? describing the various layers (sensor through to business system interfaces) as well as the hardware, software and security aspects of the DCS.
send me last 5 years questions asked in rrb chennai, for section engineer
Punj lloyd is coming in our Jadavpur Universtiy campus for campus placement. Please send me some hints about the writtend exam. My email id is subratafriends@gmail.com
use of split range ? where it is used ? in which control loop it is used ?
please send me some question papers of HPCL aptitude test ?? please send it to bipinb.28@gmail.com ...
A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.
hello friends, can you please send me the model paper or question paper to be prepared for hpcl examinations????????? You can mail me at rahim_here@yahoo.com waiting for your reply........... help me .. plz.....
sir i m preparing for BARC but i am not getting any papers to prepare for this exam so please send me some sample papers to my i.d for the preparation of barc.
give me all the details about the interview and which type of question being asked
hi i am eswar i want to know the instrumentation interview questations for eil(engineers india ltd) i have applied for engineer post in eil please help in this.my mail id eswar310@gmail.com
where cascade loop use ?
Questions on flow meters,few questions on HART protocol,
any body please send me the old question papers of ongc test.
