Interested to Buy Any Domain ? << Click Here >> for more details...
where do you give the 4-20 ma i/p in a MIL control valve?
- 3 Answers
- 9371 Views
- Siemens, I also Faced
- E-Mail Answers
Answer Posted / gsn murthy
the input of the MIL control valve normally in I/P (current
to pnuematic convertor) or direct mounted of E/I.
| Is This Answer Correct ? | 6 Yes | 1 No |
Post New Answer View All Answers
How to calibrate level transmitter with use of HART?
Where are oxygen analysers installed in cfbc boilers? What are their usual readings?
Hi, Is there any smart plant instrumentation design training institute in Bangalore?
Calibration of controller (pneumatic)
how to control pid
give some question relative instrument fitter?
sir ,iam in dem urgent need of HPCL Paper of Instrumentation Branch plz send me at your earliest convenience at ujjwal_sharma1983@yahoo.com
What is the difference bitween control net scaner and device net scaner
how many type conductivity sensor ?
What is furnace draft control?
steps for installing orifice plate?
How the sizing of the analog signal cable is calculate?
How u measure the massflow in orifice flow measurement techniques
What is critcal speed. what is resonant frequency. why we want to cross crtcal speed on higher RPM (early).
Hello to all....I am an Instrumentation Graduate and i am passed out in this year only.. I am unable to find the job in my core instrumentation.. so any boby tell me how to and where to search the job....please...and also tell me i there are any courses offered in the instrumentation stream so i can do it... you can send your suggestions to my mail-id i.e Ganesh20084u@gmail.com ... please..
