Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / pawan
UPS- UNINTERRUPTED POWER SUPPLY.It is a power backup device
without any interruption to load.
1)offline ups(single conversion,AC TO DC OR DC TO AC AT A
TIME & hence change over time to toggle between them)
2) on line ups(Double conversion,AC TO DC than DC TO AC all
the time & hence absolutely no interruption)
| Is This Answer Correct ? | 7 Yes | 1 No |
Post New Answer View All Answers
1 Ton is equal to how many watts?
There are Two questions about Steam Turbine Generator... What is HRSG bypass of LP, HP used for in power generation? In particualar, in the event that fault of HP bypass, there would be STG TRIP in operation but none on the LP bypass fault...what's the reason ?
WHAT IS THE DIFFERENCE BETWEEN GENERAL INVERTER AND SOLOR INVERTER TELL ME PLZ
What effect does a very low impedance have on the Voltage regulation? On the short-circuit current?
Hi guys! Plz help me to answer the following questions. 1. What are the types of transmission line energy losses? 2. Why are the VLF are used some types of services? 3. What frequencies are used for reliable beyond the horizon terrestrial communication without repeaters? 4. To permit selection of 1 out 16 equi-probable, what is the number of bitis required? 5. What is the most common modulation used for telegraphy? 6. What is the multiplexing is used to increase the capacity of the optic fiber? Thanks
Differentiate between low pass, high pass and band pass filter?
how to control dc motor?
Whether power factor should be high or low? Why?
What is the working mechanism of OLTC in Power Transformers????
What's the difference between non break power supply and non break non short break power supply
Define filter?
explain the process of commutation in a dc machine. Explain what are inter-poles and why they are required in a dc machine.
What is systematic error?
Pl. share your experience about industrial-electronics repair of machine tool.
I need to connect a synchronous generator to the grid using automatic synchronization and two circuit breakers (one for synchronization, one for end connection to the grid), how to determinate the required diameter of the cables?
