what happen if we give 220 volts dc supply to d bulb r tube
light?
- 9 Answers
- 21427 Views
- NHPC, I also Faced
- E-Mail Answers
Answer Posted / ranveer singh
nothing will happn only bulb will blast.
| Is This Answer Correct ? | 6 Yes | 19 No |
Post New Answer View All Answers
What is Instantaneous Earth fault relay,how will work
1) why a dg set shows variation of power factor and load when synchronised with other dgs? 2)Why the load sharing is not become equal in all dgs?. 3)When a dg set will not run on auto start?
What will be the output voltage of a transformer if it is primarily energized from a square wave voltage source?
what is the solution for meger test failed the MV cable?
why we r not earthed Control cable of C.T. terminals
Why power factor should not be in leading (capacitive) mode of any load.
1.why are not using acb 33kv ht side? is there any problem 2.what is difference between acb,vcb,sf6 breackers? 3.what is the function of invertor and convertor in ups?
what is the difference b/w ATS and HTS?
What is the difference between multimeter
A 3 phase transformer's (Y-Y) Y and B phase is (Y and B connection not broken) broken from neutral and R and Nutral connection is ok, what will be the relay tripping and why
what are the interview question asked in wind mill about electrical
I have 2 KW electric water heater.I am gonna use it in controlling water temp.so I needed to increase or decrease the heating capacity.is there any electrical-electronic circuit for varying the resistance & so current?
what are all types of cross section in AC cables?
Explain the function and difference of Restricted earth fault, simple earth fault and sensitive earth fault with connection diagram.
which capacity of RCCB used for five thousand watt electricity load?
