Interested to Buy Any Domain ? << Click Here >> for more details...
What are the tests to be taken on a transformer and
generator?
- 12 Answers
- 41124 Views
- Honeywell, I also Faced
- E-Mail Answers
Answer Posted / sachin rai
HI I am sachin rai working in mahindra automotive
sector,pune, here is the list of all tests carried out of
testing transformer. if u want know more about it pls mail
at rai.sachin21 @gmail.com
1. Voltage ratio test To measure voltage ratio between
windings of transformer
2. Polarity
3. Phase relation test
4. Resistance measurements
5. No-load loss test
6. Exciting current test
7.Load loss and impedance test
8.Induce potential test
9. Applied potential test
10. Oil test
11. Insulation resistance test
12. Leakage test
13. Temperature-rise test
14. Dielectric type test (Lightning and switching Impulse
test, BIL)
15. Dielectric special test BIL FW&CW
16. Determination of capacitance winding-to-earth, and
between windings
17. Measurement Zero-sequence impedance on three phase
transformer
18. Determination of sound level
19. Measurement of the dissipation factor (tan d) of the
insulation system capacitance
20. Determination of partial discharge on transformer
| Is This Answer Correct ? | 22 Yes | 1 No |
Post New Answer View All Answers
how to select rating of HT Panel
which is chemical used as in ro water what is difference betweeen multi grade filter&dual media filter
what is the series parallel connection of capacitors? and how can we use these application in three phase motors for controlling torque?
how rectifier transformer work in electroststic precipetatore(esp?
what happen if the load connected to the induction motor is taken away? the same question for synchoronous generator in synch i think that the the exitation voltage will appear on the terminal only if so plz answer me
what are the condition that makes hooter blow?
HOW MANY TYPES OF FUSE?
Why can't we take NO LOAD TRIAL of motors having V1 mounting??
how do i commission a distribution transformer knowing all its ratings and transformation ratios?d
how to find the torque of the single phase synchronous motor by doing an experiment
how can motor both beasrings insulation resistance can be check?
is oil viscosity affect on motor current?
Why can't we parallel the secondary circuits of two voltage transformers?
how can service sitting be setted for MCCB?Example for sittings IR (CURRENT RATING),IS(CURRENT STARTING) I O (current operating)?
When we use air circuit breaker, it has O/L protection ,time delay SC protection, Instataneous SC protection & ground fault protection. They all have some setting range. But what is the suitable/allowable setting for the above protection which will be safe for the equipment? For example-O/L protection setting have a range of (0.4,0.45,0.5,0.55,0.6,0.65,0.7,0.8,0.9,1.0)xIn Time delay SC protection have a range of (1.25,1.5,2,3,4,6,8,10,12)xIn Time delay setting is 0.02,0.1,0.2,0.3,0.4 Instataneous setting is fixed to 20xIn Gound fault setting is given 100A,300A,600A,900A,1200A This setting are for 2500A ACB. So what will be the basic allowable setting for the above protection? is there any formulae to calculate this<
