thermal power station operation in general
Answer Posted / arun
in thermal power station the main aim is we need to heat
the water which contains in boiler to get high velocity
steam.for that in boiler below to that coal will be burning
always... by eating of coal, water will get heated and
converted into steam...with high velocity.now such a steam
will be appiled to turbines..now turbine gets rotated..the
generator that is prime mover of turbine,also gets
rotated..so we get electrical power from thermal power
plant..
for achieving above we need lot of physical arrangemnts
such that...economiser,steam tubes,boiler,coal,water.....
Is This Answer Correct ? | 34 Yes | 3 No |
Post New Answer View All Answers
How much load can take a 16 mm aluminum cable 3 phase
in power generator normaly voltagr betwween esth to neutral is 0 but my work place generator show the volatge is 60v any body know why? thanks
kVA rating of ordinary transformer is increased when connected as an auto transformer because A transformation ratio increased B secondary voltage increased C energy is transferred both inductively and conductively D secondary current increased
how do you choose the cable size as per amps rating & the voltage drop for the same.
What is meant by control system?
work of choke in florocent tube circuit ?
How is the gain affected by the introduction of feedback in a control system.
Mention the disadvantages of low power factor? How can it be improved?
What are the temperature elements?
how many single tension hardware are required on a double circuit transmission tower?
If not into production, how far did you follow the design and why did not you see it into production?
what is the VA(Volt-amphere)? define with calculation?
Can any one know what are the symbols at the down (below) the analog ammeter??? there are 4 symbols which are they ?????
we all know voltage is a force(emf), and the force always devides if 2 or more than2 loads are there but why does the voltage remains same is parallel, it must devide na ???
what is metering cum synchronizing panel and how it is used?