Answer Posted / preti
resistor is a two terminal electronic component that
produces a voltage across its terminals that is
proportional to the electronic current through it.
where as resistance is the property of a resistor.
resistance relay on ohm's law
according to ohms law
V=IR
| Is This Answer Correct ? | 5 Yes | 7 No |
Post New Answer View All Answers
Difference between on line capacitor and Station type capacitor
what is the difference between elcb and rccb ?
RATING OF LIGHTENING ARRESTER FOR 11 KV LINE IS 9 KV is ok ,but haw to calculate the KA rating?
why we use single core 630mm2 cable for transformer secondary side
mostly the questions were from machines... d.c. machines, transformer, synchronous and induction all theory paper........ few from power system... but the level of paper was easy.....
how to find the torque of the single phase synchronous motor by doing an experiment
In general bus riser follows the bus section in SWGR. What are impacts if bus section follows bus riser?
why do we not use equivalent voltage source in negative sequence equivalent ckt.
Is there a possibility to use such a treshold voltage for the NMOS part of a CMOS circuit that during the switching it will start conducting only after the PMOS part will be already closed, by this eliminating the leakedge current? Please note, I'm not asking about the well bias in standby mode, but about the "antileakedge" measures during normal operation.
What is different between Difnit time and instatous over current relay
plz send me the procedure and syllabus for mseb exam
What will happen if the d.c. Machine is operated below rated speed?
Which do you think is the most significant cause of energy loss in a factory?
what are the Alarm, Trip & Safety equipment (Issues) present in Power Transformers pls Mail it to ashokbabunhce@gmail.com
sir i have a car stereo system and there is jack on him so can u tell me a way to find out their power terminals on the jack or on the circuit board"