Answer Posted / awaneesh
Flange rating basically refers to the amount of pressure
the line/flange can handle.
As per EIL standards, it is available in
150/300/450/600/900/1500/2500 psi. So dividing this figure
by 14.2 , we can get the rating in Kg/cm2.
| Is This Answer Correct ? | 12 Yes | 6 No |
Post New Answer View All Answers
What is wrap-around?
Cox chart is used in ....Distillation, evaporation, drying
What is volumatric air change of a HOT GAS GENERATOR of a STEAM BOILER ?
what is the function of platern water wall in a boiler? and difference between with ordinary water wall?
How can check gear pitch?
What is a cotter joint?
What is hertz in electrical system?
If any changes done in the process of production what that is called.
if any one attended caterpillar placement pls send the model questions and the question pattern.....
How much is 1 kn in kg?
What is an expansion valve and its purpose?
Explain bearing
What for admirality brass used ?
Steering handle (round dial) of motor vehicles (CAR,BUS,LORRY) wiil be designing with two cross supports without 180 degree straightness( it will be little bit cross). Why?
I am requiering interview questions regarding Close Ferro Crome Furnaces
