Interested to Buy Any Domain ? << Click Here >> for more details...
How to calculate cable sizes in sq.mm. with using motor KW?
Any formula there?
- 18 Answers
- 306044 Views
- Aswani Properties, BRB Cable, Construction, Hitachi, L&T, Microcool Systems, Nahar, NWPF, Reliance, Renault, Saha Bright Polytech, SGH, TATA, Techno Electric and Engineering, TFIL, Thermax, I also Faced
- E-Mail Answers
Answer Posted / raja
THE ABOVE SAID IS WRONG , ITS A THUMB RULE I USE TO FALLOW
1 sqmm = 5A & endangering amps withstand is 8A for alu
(sqmm * 1.87A)for cu sqmm *2
| Is This Answer Correct ? | 25 Yes | 44 No |
Post New Answer View All Answers
WHAT IS SPEC OF CLEANROOM MOTOR AND LIGHT FITTINGS?
In hydel power plants, L.A's, S.C's are placed inside the control panel boards. what is the purpose? [already the total body was earthed to ground.]
what is the standard values(Megger test) of resistances between L&N,L&E and N&E for a system on IEE regulations?
What is the method to solve circuit using source transformation?
Why different Pressure switch used in marine boiler water circulation system
How earthing/grounding done in aeroplanes and ships.
1.what is the funtion of chiller primary & scondary pumps. 2.what is the use of distribution lines & Types. 3.what is the use the thermal power stations & how much capacity.
How would you calculate power loss in a resistor?
my question is how to answer the question "you are from b.tech eee background and why do you want to go for banking
Can a generator runs after getting 1st stator earth fault.
How does a battary stores charge in it? please explain in simple manner and in detail.thanks
what is the transmission loss for electrical supply? specifically a large shopping complex where the grid is half KM away, what will the % of transmission loss? is there any transmission loss for captive unit generation for above set? thanks
How much pf maintan in dg set in 6o% load,when Dg runnig Neutaal Earthing removed what happen.
WHY DO VOLTAGE TRANSFORMERS FAIL DURING EARTH FAULT IN THE DELTA CONNECTED 6.6KV ELECTRICAL SYSTEM
In what cases (circumstances)we should apply P controller, PD controller, PI controller & PID controller ?
