Interested to Buy Any Domain ? << Click Here >> for more details...
The administrator of a comapny needs to ensure that a web
server in
their network is accessible from the Internet. Since the
network uses private
addressing, this requires an IP-to-registered-address
mapping. The following
command is entered on the router:
router(config)# ip nat inside source static 192.168.2.1
198.18.1.254
After unsuccessful results from a ping to the Internet, the
administrator issues the
show ip nat translations command and the output is blank.
What could be the
problem with the NAT configuration for this mapping?
A. The keyword overload is missing from the command.
B. The administrator needs to define a NAT pool first.
C. An access list must be defined to create static NAT
translations.
D. The interfaces need to be configured for NAT.
- 4 Answers
- 7635 Views
- I also Faced
- E-Mail Answers
Answer Posted / jitendera kuaar sinha
Answer for that question-
After all configuration, do i hv to go to each switch &
configure each port manually or ya on VTP server i cud do
this. I mean assigning interface to VLAN.
answer-vtp is a vlan mangment protocol by this any netowrk
admnistrator can add ,delete,reconfigure the specfic vlan
then you cou do this on vtp sever.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
How many parts of ping?
What are the advantages of using switches?
What is the beaconing?
What is the difference between csma/ca?
What are the protocol data units (pdu) in ccna?
What is a Frame Relay?
How many ways to access router?
Explain the draw back of eigrp protocol?
What is subnetting? Why is it used?
What is the purpose of a data link?
Explain the difference between switch & hub?
Define load balancing?
What is half duplex and full duplex?
Which type of routing you did in ccna?
What are the possible ways of data transmission in ccna?
