Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / jitendera kumar sinha
In Ethernet switched environments where multiple Virtual
LANs exist, spanning tree can be implemented at each
vlan . and it is named as per VLAN spanning tree (PVST and
PVST+, which is the default protocol used by Cisco
switches). Both PVST and PVST+ protocols are Cisco
proprietary protocols.Since PVST treats each VLAN as a
separate network, it has the ability to load balance
traffic (at layer-2) by forwarding some VLANs on one trunk
and other Vlans on another trunk without causing a Spanning
Tree loop.
here one point is noted that scinse it is a
ciscoproprietary so it use isl encapsulation for trunking.
if you want to know that how to do that then here i canot
expalin how toconfigure that pvst+
| Is This Answer Correct ? | 2 Yes | 3 No |
Post New Answer View All Answers
When we use interface mode?
When we use loop back ip?
What are the steps of conversion for data encapsulation?
What is the multicast routing?
What are the ranges for the private ips?
What is default cost of serial interface in ospf?
What is hold down time formula of ospf?
What is difference between rip and ripv2?
Tell me which cable we connect in db-9?
Which protocols are link states?
What does the show protocol display?
In which protocol you manually enable route summarization?
Briefly explain the conversion steps in data encapsulation.
Mention what command you must use if you want to delete or remove the configuration data that is stored in the nvram?
1350 Value in which type of access-list?
