Interested to Buy Any Domain ? << Click Here >> for more details...
When capacitor bank connect on line. It's draw some current
but it's current not increase of main line ammeter. Why?
- 1 Answers
- 6159 Views
- MCL, Star Wire, I also Faced
- E-Mail Answers
Answer Posted / dhanesh
It is true only in case of a Load which is running a poor
power factor because capacitor draws the Leading current
which cancel outs the lagging current of load and thus no
current drawn from line but if a load which already having a
good power factor capacitor will draw the leading current
from the line.
For checking this fact, just switch on a capacitor on the
panel when there is no load condition.
| Is This Answer Correct ? | 18 Yes | 1 No |
Post New Answer View All Answers
how can we phase identification in a distribution line,how we recognise that which phase is coming for a house hold connection.help me............
what is difference between line differential and transformer differential?
how can get electrical c licence.now i am working in spining mill , transformer capacity 2750KVA. SANCTION DEMAND 2250KVA. PLEASE ADVISE ME . MY CONTACT NO 09944226823
Good morning: I'm looking for some informations about the OLTC or the LTC: I wont to know what the function of the tie-resistor in during the operation of reversing/coarse operation Cordially
Control wiring of a dol starter for forward and backward
what is the ground fault relay,which purpose it will be use,clearly tell me plz
A double circuit with dog conductor 66KV Transmission line from wind farm evacuation to feeding substation having capacity of 25MW for transmission. Can same transmission network be considered for further expansion of Power & how much in MW. If we need to expand next 10-15 MW more will there any augmentation is required in transmission network? Kindly reply asap.
How short circuit MVA(Fault MVA) in a power system calculated for calculating number of earth plates ?
How will polarity test of Dy5 Transformer ?
What are the components connected in between the power supply coming from an electric pole to HT & LT Panels in a large commercial building or how the power supply connected from Electric pole to Transformer & then to the HT & LT panels of a building? Please send me answers via mail, my id is yogiagarwal@gmail.com. If possible, please give a line diagram.
What is slope...? Explain slope 1 and slope 2...?
do you have some of interview Questions in power and genrator section in general whith answers
How out of step protection relay works?
how we can adjust for three phase motor cold stall time ,hot stall time and thermal register set up?
sometime battery charged and then automatically charged when rectifier ON conition, is there any chances please clarify the same.
