Interested to Buy Any Domain ? << Click Here >> for more details...
Hi Guys i hv one confusion. Need u peoples help.
In EIGRP, maximum hop count is up to 255. By default only
100. Now question is -
a) Suppose i hv a network consist of 115 routers & EIGRP
routing protocol is configured. By default hop count is 100,
so is there any manual configuration necessary for hop count
ya router will automatically detect the hop count & will
update the hop count accordingly..?????
b) In EIGRP, Bandwidth & Delay is used to calculate metric.
For this Metric weight is set to K1(Bandwidth)=1,
K2(Delay)=0, K3(Reliability)=1, K4(Load)=0, K5(MTU)=0
Now i want, Bandwidth & Load is used to calculate metric.
For that wat i hv to configure & wat wub the metric weights.
Cud anyone explain it plzzzz..!!!!
- 5 Answers
- 7537 Views
- I also Faced
- E-Mail Answers
Answer Posted / jitendera kumar sinha
hi sahin.now i am trying to giver your all three question but one thing is necessary to know that what is default. default is that which can be configurable. now in the eigrp determination of path done by cost. that is cost==10^8/bandwidth now the path which have best cost is selected as best path that is the path have lower cost selected as best path. one point is noticeable that eigrp use only bandwidth and delay to path calculation .mtu is never used for path calculation but it is a important parameter for eigrp related command. how to configure bandwidth of eigrp Set the bandwidth on your interfaces using the bandwidth command Router (config-if)# bandwidth XX(if you want bandwidth 5600 simply write 56 not 5600) this is the command by which you can configure your bandwidth now back to your first question. 1 now you are going to change the metric value that is "k" the what happen here is the answer k=ad value/bandwidth(Wright)for eigrp ok ad value is constant(let) now you can change only bandwidth value now as we discus earlier that path determination is based on bandwidth so as you increase the bandwidth cost decrees then it will be selected as best path. and if you decrease then cost increases then it kept in to routing table.
Now your second question’s have written earlier that to reduce routing overload we need redistribution in another way we can say that in the large network we need redistribution.
Now yours 3rd questions
Frankly speaking I don’t know
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
Which dynamic type draw back is, if single link down, it removes its routing table?
What is point-to-point protocol in ccna?
What is the second best path name of eigrp?
What is difference between igp and eigrp?
What is the working of router?
What is 100BaseFX?
What is an autonomous system?
What command do we give if router IOS is stuck?
Suppose we have some switch in network and we are running RSTP how much convergence time will be there if one link down
Which protocol comes under hybrid dynamic type?
Why twist in twisted pairs?
What is the syntax of ipv4?
Referring to the commands shown, what command must next be used on the branch router prior to traffic being sent to the router?
What is poe (power over ethernet)?
In which ios version 182 people can access router through telenet?
