Interested to Buy Any Domain ? << Click Here >> for more details...
hi friends i am jitendera kumar sinha.i have a question in
mind that what is the diffrence between router and l3 switch
i serched on google and found that switch L3 is best in lan
and router are best in wan and switch are more faster then
router.beside that any short of technical diffrence if you
body know then plz plz and plz reply.
my 2nd question is that why we canot replace router with L3
switches (donot tell that it is costly then router).i want
any technical cause.
this is 1 am hope in noon when ever i logg again i will find
the answer posted by you.
thanks onse again
plz pzl make reply
thanks
jitendera kumar sinha
jitenerasinha.it@gmail.com
- 5 Answers
- 6608 Views
- I also Faced
- E-Mail Answers
Answer Posted / mr.shahin07
Hi, I m Shahin Ahmed. I also don't have much knowledge on
that. Still trying to explain it. Hope it'll help you.
Layer 3 switch is a high-performance device for network
routing. Layer 3 switches actually differ very little from
routers. A Layer 3 switch can support the same routing
protocols as network routers do. Both inspect incoming
packets and make dynamic routing decisions based on the
source and destination addresses inside.
The key difference between Layer 3 switches and routers lies
in the hardware technology used to build. The hardware
inside a Layer 3 switch combine that of traditional switches
and routers, replacing some of a router's software logic
with hardware to offer better performance in some situations.
Layer 3 switches often cost less than traditional routers.
Designed for use within local networks, a Layer 3 switch
will typically not possess the WAN ports and wide area
network features a traditional.
| Is This Answer Correct ? | 3 Yes | 1 No |
Post New Answer View All Answers
GUYS i was refraining the OLD post and i got a good Question and wana make sure that you guys Just did not vist it for answers if you are not Aware google it understand it and then answered it the question is -: Significance of IP helper-address Command on SW? Is it necessary to put this command? you donot wana to give answer please donot visit this question and increase the vistor name if you are thinking that answer is wrong mark it wrong and explain why you are marking it wrong
What is syntax of ipv4?
Is hub intelligent device?
What cable called v.35?
How do areas benefit a link state inter network?
What are the different types of network in ccna?
What is half duplex and full duplex?
How can you assign a vlan to a switch port?
What are 10base5 ethernet lans?
What is the difference between csma/cd?
What is Phase od VPN in site to site and what information you will require to configure a SITE to SITE VPN
How does rip differs from igrp?
What is the key advantage of using switches?
Which company mange api's?
In which protocol supenetting is enable by default?
