Interested to Buy Any Domain ? << Click Here >> for more details...
why we commonly use delta star winding in power and
distribution transformers
- 7 Answers
- 21674 Views
- I also Faced
- E-Mail Answers
Answer Posted / aashish sharma
Delta connection is make at primary side because in delta
low harmonics(3rd,5th and 7th) produce as compare to star
while at secondary side star connection is use to provide 3
phase 4 wire system or we can say that getting singale
phase from 3 phase.
| Is This Answer Correct ? | 15 Yes | 18 No |
Post New Answer View All Answers
What is shunt voltage and u v voltage witch one best
What are the two types of compensation?
Which type of transformer is used for lighting loads?
fuel-air ratio in a petrol engine fitted with suction carburettor,operating with dirty air filter as compared to clean filter will be
why most of junction box vendors providing T5/T6 Temp class jb's for T3 area any special reason?
what is diff. between earthing grid,earthing mess, earting grid?
How many gap between finger contact in a.c.b. and v.cb.?
induction 3 phase motor terminal connection
Transmission through a short line depends on
what is the effect of back reactive power on the generator ?
how much value of resistance should connect to 15 kw, 6 pole 3 phase slip ring induction motor having RV-240, RA-42.
What is Long rod insulator and it's applications..? merits over the disc insulator ..?
low frequency protection why recomend?
wish of these transformer uses oil?
Why we use duplex coil and hook switch in telephone system?
