Answer Posted / ashish jain
in case of C.T. It is the value of voltage above which
there is a sudden increase of current i.e. with 10%
increase in voltage, there is 30% increase in current
(approx). below this voltage the V/I
charachteristics is almost linear.
| Is This Answer Correct ? | 5 Yes | 5 No |
Post New Answer View All Answers
Explain what is rated speed?
what is ps impedance test
Differentiate between kirchhoff’s first law and kirchhoff’s second law?
To make a basic instrumentation amplifier, it takes A One op-amp with a certain feedback arrangement B Two op-amp and seven resistors C Three op-amps and seven capacitors D Three op-amps and seven resistors
Explain with example of functional requirements of protection relay in terms reliability, selectivity, sensitivity
Where can i get practical knowledge of solar system?
what is the k var ratting of 1250kva
Power factor =1.000 at factory in supply. However, PF = 0.8 at motor end. Current = 100 Amp, Voltage = 400 V. What is the power distribution loss? Can I reduce it by adding capacitor at the load feeder?
best manufacturer for busbar for outdoor switchyard having double bus bar scheme, can any one share technical specification of busbar. 132kv voltage ?
How much inductance or resistance require as a starter in series with induction motor of specific capacity(e.g. 5 hp) ? What is formula for it ?
What current flows in the transformer primary when its secondary is open?
What the difference between three phase contactor (coil 110vac) & three phase SSR (control voltage 110Vac)? May I use contactor in place of SSR?
A 50Hz,4-pole,3-phase,star-connected synchronous motor has a synchronous reactance of 12ohmsper phase and negligible armature resistances.the excitation is such as to give an open-circuit voltage of 13.2kilovolt.the motor is connected to 115kilovolt, 50hertz supplying. what maximum load can be the motor torque,line current and power factor?
pls tell me function of closing coil of A.C.B.
What type interview questions ask in Electrical technicians