Answer Posted / karthik

Based on the instrument settings, two known solution shoud
be used for calibration. For example, take 4 mS solution,
immerse the probe and press calibrate option in the display
menu, after 2/3 seconds it will ask like solution1
calibration ok, put solution2?. you have to press yes
button. As per the set(example-7)value, u must put second
known 7 value solution in it. if it is ok. it will finally
ask for calibration over, exit? press yes

what does it mean an active front end in vfd plz explain it briefly

1853

---

Describe how to use megger to measure the earth resistance and insulation resistance

2206

---

what is loop1 and loop2 in MTS LT?

4639

---

Dear Friends, we are planning to design Power distribution and Fiber optic in the same cabinet.Like Front side Fiber optic and Rear side Power distribution.Is it any possibility of problem occurs like interference etc? Your answer is highly appreciate.

2194

---

Q-Explain the different load conditions that will produced different offset which may or may not be acceptable to thhe control function

2171

---

IS there any effect of vortex in low pressure side of the transmiter after the orific in feed water line? if yes then what is the calculation?

2384

---

What types of Instrumentation Related Questions can an Interviewer ask in a Telephonic Interview ?

2490

---

How to erection of DCS Panel at site step by step

1488

---

In power plant to measure vibration of a turbine we install sensors. Before install this sensor we have to set gap voltage. What is meant by gap voltage and its use?

2057

---

any body who gone thru recent iocl interview.INSTRUMENTATION questions. I need.

2468

---

What is the purpose of the analyzer in petrochemical plant?

3851

---

give eg of how I/P is used in control loops

1920

---

WHAT IS TMXT IN TEMPERATURE FOUNDATION FIELDBUS.

2297

---

applications of plc in printing and packaging?

2172

---

What is sensitivity in vibration probes..?

1616

---