Interested to Buy Any Domain ? << Click Here >> for more details...
To check the earth condition (In plug points); the voltage
between earth and Neutral is in below 5 volts. Is it
correct
- 6 Answers
- 9048 Views
- I also Faced
- E-Mail Answers
Answer Posted / prakash veer singh
Yes, this is right if earthing condition is good . than the
voltage b/t earth and nutral is less than 5 volt . in
moutain aria , it is about to less than 8 volt .
| Is This Answer Correct ? | 8 Yes | 2 No |
Post New Answer View All Answers
Write the current equation in series RLC circuits.
What is power factor why we should maintain the power factor unless what will happen
Refernce currents are to be generated using refernce cueernts how can this be done
WHY CBCT USE ONLY IN Y PHASE NOT OTHER PHASES
how a resistor resists to flow the current?how an inductor oppses the sudden change in current?how a capacitor opposes a DC voltage.
how to find impedance , mutual indatnce in transmission lines
why the carbon brushes are broken in srim while the motor runningtime
can anyone explain the star-delta motor control wiring ,which wire go where and how they operate?
Why choke coil is connected in series with starter in tubelight??why starter is connected in parallel to tubelight??
ROC converges if pole and zero lies inside a) origin b) z=1 c) pole d) zero ? Explanation please? if ROC does not converges then?
What will happen if the d.c. Machine is operated below rated speed?
What are the types of windings according to the construction?
need to make a report. Need to choose a 3phase induction motor. Load conditions motor will operate in : Maximum Load: 30 Kw Speed: 2950 rpm Ambient temp: 20 cent Supply voltage: 440V Frequency: 50Hz need to look for the safety factor when choosing the motor, went through catalouge found a few, but dont know how to choose the safety factor allowing an extra load something above 30 KW to avoid any harm.
i completed my DEEE. and i want to electrical c license. how to get it..?
ASTM D 3455 - Standard Test Methods for Compatibility of Construction Material with Electrical Insulating Oil of Petroleum Origin has been used for Testing Transformer Oils with a product placed in it. Aged Control Oil has a Power Factor of 0.032% at 100°C. Aged Oil with a Test component has a Power Factor of 0.093% at 100°. Is this increase acceptable? If not why? How much increase is acceptable?
