Interested to Buy Any Domain ? << Click Here >> for more details...
Why only negative 24 vdc supply give in vibration measuring
system.
- 6 Answers
- 17684 Views
- I also Faced
- E-Mail Answers
Answer Posted / nandan
The principle is that analyzer supplies a negative voltage
to transducer,who converts it into a frequency & sends it
across the probe.Now as the probe comes into the area of
rotor it creates a magnetic field & with it eddy current is
produced on the rotor side.Which changes the amplitude of
the frequency.It induces the voltage & remaining frequency
comes to the transducer through the return way.Transducer
converts it into the voltage .
Now coming back to the question The gap voltage has a
negative relation with the voltage induced i.e. as the gap
increases the induced voltage decreases.So to make it to
into a linear relation ship, negative voltage is supplied.
i.e
Gap Gap voltage
0 mm 0 vtg
1 mm -9 voltage
2 mm 18 voltage
& when the probe is in air it will have no induced voltage
so all -24 voltage without induced voltage will return back.
| Is This Answer Correct ? | 16 Yes | 7 No |
Post New Answer View All Answers
explain key exchanges in all security modes WPA,WPA2,TLS?
detail of mass flow meter pricipal
What is voltage regulator?
Why do we have earthing cable in branch cable and shield in the same cable?
Tell me the field calibration procedure step by step with diagram of pressure gauge, pressure switch, pressure transmitter, temperature switch, level switch, flow switch, flow transmitter.
what is the procedure of O2 sensor(ABB) calibration?
What is the GK Value in Flowmeter?
Where Can i take a SPI INtools training in Mumbai? In Rolta India Ltd to whom I should approach regarding of SPI INtools Training?
(1) In turbine, what does term CDP, NI, NH, HSSOC, means. (2) What is the purpose of LO overhead tank in turbines.(3) An equipment is certified for EEX, IA, IIC,T6, what do you under stand by this.(4) what is SURGE, and how it is prevented, what is the purpose of bypass valve across AS valve.(5) Give 2 application of quartz crystal used for process parameter measurement.(6) what is meant by cold float of compressor shaft. (7) state four different types of flow measurement. For gas flow measurement mmscfd is the common unit. Expand the unit and specify significance of word S in the unit.(8) what is meant by Gap voltage, in vibration measurement. Normally how much Gap voltage is set and state the reason.(9) what will the new flow factor if D/P transmitter is Re-Ranged from 25” wc to 50” wc.(10) what is the usage of QDV & Volume booster.
Im having problems with interfase betwen SPI v7.0 and SPPID v5.05. Previous versions of Intools shoul be fixed with SPPIDproj.ocx file. It was necessary to replace this file with one that allows the connection between different versions of SPPID. It is necessary in the current version to do the same?Thanks
How to calibration coriolis flow meter?
Hi my friends Is any one who can assist me in knowing the typical interview questions for system engineer at General Electric pty Ltd
you are on site,the plant trips,you are approached by operations,what do you do?
any body who gone thru recent iocl interview.INSTRUMENTATION questions. I need.
How d.p. Transmitter can be applied to close tank?
