Interested to Buy Any Domain ? << Click Here >> for more details...
What power factor maintain you maintain at u r organisation
- 14 Answers
- 20842 Views
- Wheels India, I also Faced
- E-Mail Answers
Answer Posted / laxminarayan
In Industrial sector there are more inductive loads.The
inductive loads draws more load current.So maximum will be
the power factor less will be the load currnt.So power
factor should be maintained 0.97 to 0.99
| Is This Answer Correct ? | 9 Yes | 1 No |
Post New Answer View All Answers
how does ELR works? explain
What is the Current equation in series RLC circuits.
explain the types of drives
In general bus riser follows the bus section in SWGR. What are impacts if bus section follows bus riser?
how maney type tempereture measurement ?
is there any phase difference occurs while primary and secondary side mutual induction occurs?
List out the different frequency domain specifications?
hi guys please tell me the procedure for mesuring the coil resistance of 3ph induction motor?
Can XLPE/SWB/PVC (P3) 7C X 2.5mm2 be replaced by Can XLPE/SWB/PVC (P2) 7C X 2.5mm2??? P3 vs P2
CAN WE CALCULATE THE NEGATIVE SEQUENCE AND ZERO SEQUENCE REACTANCE OF A GENERATOR USING ONLY ITS RATED VOLTAGE, KW, PF AND SYNCHRONOUS REACTANCE??? IF YES, THEN HOW??
State how to produce a constant rotating field by application of alternating currents to stator armature of a three-phase squirrel-cage induction motor
I have a drawing of a wound rotor induction motor for a crane. This crane motor has 5 forward speeds & 5 reverse speed implemented of course with different amount of resistance for each speed setting selected. What has got me scratching around is the fact that 8 of the 10 speed selections switch in uneven (unbalanced) amounts of resistances on each of the 3 connections to the motor's rotor.Can this be possible? I would have assumed this would produce unbalanced rotor currents and therefore vibration in the motor. I would greatly appreciate anyone's comments on this. Many thanks, Confused.
How o select the electrical fuse?.What are its characteristics.How to select the material od fuse?
I meggared my 2c*70 sq mm AL AR XLPE cable. its one end show 50 M ohm . is my cable is safe for laying. I have only one phase and neutral.
how a resistor resists to flow the current?how an inductor oppses the sudden change in current?how a capacitor opposes a DC voltage.
