Answer Posted / venkatesh

For a single DG set, 4 earthpits will be required - 2 for
body & 2 for neutral.Suppose you have 3 DG sets then 12
earthpits will be required - 6 for body earthing of all
three DGs (2 for each DG) & 6 for neutral (2 for each DG).
The two earthpits for body shall be in grid. The two
earthpits for neutral of a DG shall also be in grid, but
earthpits for neutral of different DGs shall not be in grid.

What for schmidt plot for is used in heat transfer problems ?

1137

---

CATIA:SPRING WITH SOME RADIUS AXIS

2450

---

What is meant by indirect contact heat exchanger?

1184

---

What is screw,centrifugal and rotary type compressors,how it works and what is principle .

2003

---

Is there a lower limit to the gland surface finish for static O-rings, gaseous system? surface finish table lists 0.41-0.81 micro-meters for static gaseous systems. What is the drawback of using a smoother surface finish lower than 0.41?

1920

---

what are the parameters are selected while manufacturing a single cylinder block?what are the different kind of test is conducted on it so that it can withstand with all those condition which required to run the engine efficiently.which force is act when piston slide inside the cylinder.

2061

---

Give five differences between suction and discharge pipes?

2132

---

What is the principle of a pump?

1154

---

Which factors influence the type of fracture in failure of a material ?

1115

---

sir,i am golng to attend BHEL supervisor trainee personal interview on 11 sept.anyone share me that how could i perform well in interview& what they would expect from me. thank you.

3882

---

If any machinery or trnsmission needs periodic and regular lubrication what is the best method to give?

1897

---

what is mean by cc critical characteristic, hic high impact characteristic

3533

---

Explain the advantages of diesel engines?

1212

---

why the wear of back tyre takes place more rapidly than front?

2026

---

what is routh,s law in thermal engineering ?

2186

---