Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / rajendran
In order to reduce the stroboscopic effect, we are normally
using the twin lamp fittings in the factories...
| Is This Answer Correct ? | 8 Yes | 0 No |
Post New Answer View All Answers
Alternator rotor earth fault relay circuit
what is mean by restructuring power system?
What is the difference between diesel generator engine with and without turbo charger with the same capacity?
What is the formula for calculating impedance of transformers connected parallel at fault level 50KA?
Why we use circular(Stepped) cross section in transformer core?
Iwould like to know barc interview questions
How to work definite,over pluxing,revers power,OSR relay
Explain mechanical rotational system?
I am getting above 60 V as open delta voltage against single phase unit ICT at tertiary delta formed and ICT getting trippped on NDR. ICT tested and found in order. PTs provided on tertiary are tested and in order. what may be the reason?
any one can explain the stages of a knee point which is taken during ct magnetising curve.
how to revers the direction of single phase motor
What is the use of bundle conductors?
Shall I use 40A semiconductor Fuses in 32 A SFU ? Frame size is same. What Happen if Fuses burn on SFU?
apti mainly on logical reasoning, verbal and non-verbal ability (70 percent) and remaining technical. I was in ee but technical had mech ques like on turbines and welding.
In Electrical 'Single Line Diagram' cable nomenclature shows "2 X 1C X 630sq.mm to be provided for one incomer. The question is how many cable to be proved for one Incomer.
