Interested to Buy Any Domain ? << Click Here >> for more details...
explain why the secondary terminal of current transformer
should not be lift open circuited.
- 2 Answers
- 8512 Views
- I also Faced
- E-Mail Answers
Answer Posted / gulshan goyal
the mmf developed in the primary side will depend only on
load current which is highdue to which there will be high
flux in secondary also hence if we open circuit the
secondary the current present in sec will be zero,a very
high voltage will be generated which cause hazard.
| Is This Answer Correct ? | 3 Yes | 1 No |
Post New Answer View All Answers
please give me all the Alarm .Trip ,Safety Relays & Conditions of Chiller mail me on ashokbabunhce@gmail.com
What is meant by Low Resistance Cable and High Resistance Cable.
IF % IMPEDANCE OF A TRANSFORMER IS INCREASED FROM 5.8% TO 8% HOW MUCH THE EFFICIENCY OF THE TRANSFORMER WILL COME DOWN?
As per standard, transformer body earthing and other Equipment earthing (Equipment earthing) did not connect. but in LT side termination we are doing metal glanding in both side Transformer to PCC Panel through armoured cable, now X'mer body earthing and PCC Pane earthing (Equipment earthing) both are connect.is this safe for X'mer or other equipment?
If VFD is On but no starting commond on it. so how many outpout voltages of VFD
In single phase ac ups supply when current is measured with tong tester neutral current is found more than phase current.What is the reason?
Why derating factor os applied on Cables?
What is meant by short-pitched winding?
I FINISHED MY B.TECH IN EEE . I AM IN NEED OF A GOOD TRAINING INSTITUTE TO DO COURSES .. CAN ANYONE SUGGEST GOOD CENTRES IN TAMILNADU ,BANGALORE ,OTHER AREAS???????
How to measure power in 2 or 4 or n phase circuit? Please give me a formula.
What is the suitable transmission voltage?
1- What is the Polarization Index number be good for 15KV 3c#500MCM electrical cable? 2- Can I use the IEEE Std 43-2000 to perfom the PI test? Thanks
Difference between ac parallel circuit and ac series circuit?
we have 3 single phase transformers. how will we generate 6 supply from 3 phase supply input
How many sprinklers should be in one pipe line?
