Interested to Buy Any Domain ? << Click Here >> for more details...
what is diff between sensors and transducers.explain with
ex?
- 15 Answers
- 44220 Views
- I also Faced
- E-Mail Answers
Answer Posted / ravi
sensor output is always electric output. but transducer
output will not be a electric output always. all sensors
are transducers, but all transducers are not sensor. its
simple
| Is This Answer Correct ? | 21 Yes | 38 No |
Post New Answer View All Answers
For crude application in floating roof tank, how to calibrate a DP Transmitter? How is the floating roof weight considered?
why we are using magnet for calibration of gas detector?
How can we use feedback signal frm rtd for monitoring and in dcs for controlling ,then which type of rtd is sutaible 2 , 3,4wire and why ?
what is performance test.need defination
how many maximum enter 2mm Dia solid cylindrical pipe into 8mm Dia hollow cylindrical pipe. give answer with calculation.
Which language of programing is popular? how can i learn it ?
what is basic difference between motion balance and force balance in pneumatic instrument?
how can leve transmetter calibate in feild .and also put cv and flow plz .....
line up procedure for dp type flow transmitter?
how does we calibrate a square root flow transmitter ,give an example and explain it step by step like range calculation , calibration hook up series connection , zero check , and how to apply pressure , and if not geting proportional output then what should we do ?
how can be calibrate flow indication transmitter (rosemount) it shows excess milli amps nearly about 24 ma on full scale, but its scale was set on 20ma on full scale..???how can be simiulate..???
How we connect a instrument with ground, Give brief explanation with help of diagram?
why we use impulse line of flow transmitter at 45 deg. angle both side of orifice plate.
(1) In turbine, what does term CDP, NI, NH, HSSOC, means. (2) What is the purpose of LO overhead tank in turbines.(3) An equipment is certified for EEX, IA, IIC,T6, what do you under stand by this.(4) what is SURGE, and how it is prevented, what is the purpose of bypass valve across AS valve.(5) Give 2 application of quartz crystal used for process parameter measurement.(6) what is meant by cold float of compressor shaft. (7) state four different types of flow measurement. For gas flow measurement mmscfd is the common unit. Expand the unit and specify significance of word S in the unit.(8) what is meant by Gap voltage, in vibration measurement. Normally how much Gap voltage is set and state the reason.(9) what will the new flow factor if D/P transmitter is Re-Ranged from 25” wc to 50” wc.(10) what is the usage of QDV & Volume booster.
what is the difference between -24 : +24 & 0:24 and where it use?
