Answer Posted / ravi
depending up on the number of windings in primary and in
secondary winding,we can calculate the CT and PT rating of
the transformer.
N2/N1=V2/V1
Is This Answer Correct ? | 13 Yes | 9 No |
Post New Answer View All Answers
When calculation of fault current and fault Kva is to be done,why always we use per unit value and why we consider the base kva?
dg started in plc mode and load taken later one battery terminal connection will be disconnected by loose connection what will happen for dg and shall we connect battery terminals while dg in load time?
what about the power of wattmeter at starting and loding?
what is KA rating and how can we choose switchgears on applications
What is Percentage impedence of a transformer? why it is expressed at a percentage? what is the importance of percentage impedence in case of a transformer?
power transmission pole used one support , that only for support or earthing
how many types control panel of a 132/33 kv substation
1) What are your personal strength? 2) What are your personal areas of improvement? 3) What are your expectations from from a particular job? 4) what are your carrier objectives?
How to calculate ant test the burden of Current transformer
How does cost of generation from hydropower plant compare with other sources of electricity?
How to back charge the Gas turbine generator
how we test a 3 phase motor on single phase supply....? HOW WE RUN A 3 PHASE MOTOR ON SNIGLE PHASE. supply for testing..? how we verify of a 3 phase motors 6 wire & name thame a1/a2/a3..b1/b2/b3 and c1/c2/c3 for connecting star delta starter ........i have only 1 phase supply ? help forum..........
can indirect loading be called as phantom loading?
Why the magneti fields are not passes from southpole to north pole
What is the difference between amorphous core transformer and CRGO core transformer?.