how much % of steel use in footing, slab, column
- 18 Answers
- 152184 Views
- Bhel, Matrix, I also Faced
- E-Mail Answers
Answer Posted / ketan khatri
FOOTING - 5%,
SLAB - 35%,
COLUMN - 15%
BEAM - 40%
ETC - 5%
| Is This Answer Correct ? | 26 Yes | 121 No |
Post New Answer View All Answers
How to do base isolation using ETABS software?
Hi how r u ? hope you are fine there . Please can u tell me tha Design life of Buildings as Per ACI CODE 318-99. It will be a pleasure for me .Thanks in advance
A doubly reinforced concrete beam is 25 cm wide and 50cm deep to the centre of tension reinforcement. The centre of compression is steel is 5cm from the compression edge. The areas of the compression and the tension steel are 10.16cm2 and 12.56 cm2 if m=18 and the bending moment at the section is 7,000,000 N-cm. Calculate the stress in concrete and steel.
for G+2 residential building how much quantity of required in foundations,sub & superstructures per sq ft area
The internal dimensions of a wire house 15m*5.6m and the maximum height of piles is 2.70m. What is the maximum number of bags to be stored in two piles ?
what is stressing
2. What are the advantages of your present job, things you like about it?
How to arrive the co- efficient of all civil activities? For ex:- painting-enamel in wooden doors. co efficient is 1.8. How this is calculated
i have to give lap joint fo 1Mtr steel of dia12mm,whenever i did mistake i cut less 5cm plz tell me how much i will give lap joint so that length comes 1Mtr
need to join coaching institute in coimbatore tamilnadu ......say me the best coaching for IAS
What is the veriplus for ellips card length formula (major axis 3.4m,minar axis 2.6m spacing 0.2m
how to absorb to site basic corrections? which are the important correction?
How many cum of 9.5mm stone in 1 ton ?
what is the difference b/w full length and cutting length?
how to calculate the size of triangular ring in rcc column?
