Interested to Buy Any Domain ? << Click Here >> for more details...
Can any body give detail about orifice sizing?
- 5 Answers
- 10716 Views
- Essar, I also Faced
- E-Mail Answers
Answer Posted / sanjiv
You need proper sizing for that reynolds no should be
within limits b ratio you can sacrifice in few cases to
achieve better DP.
Vendors will not offer youb ratio less than 0.2 for your
normal flow range
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
Difference between 2-Valve Manifolds, 3-Valve Manifolds and 5-Valve Manifolds 3 with diagram
How to Calibrate Ultrasonic Level Transmitter in field
how many maximum enter 2mm Dia solid cylindrical pipe into 8mm Dia hollow cylindrical pipe. give answer with calculation.
what are the definitions of input, output, command & signal according to instruments controlled by PLC using DCS System?
what effects a surging can produce in the compressor
PT RTD Range: -200 to 500 degree celsius If I configured in DCS Lower range and Upper range . In face plate it shows red colour due to overa range how was the characteristics look If the temperature is more than operating range. how was the characteristics look . whether its in Resistance vs Temperature curve is Linear or Non linear
I m appointed as an automation trainee engineer in small firm in that I am only the one , my company give me a project on s7-200 as i m beginner I don't know how to program so please send me the helpful site so that I complete my project before deadline....please help me out in this critical situation.
Tr. Wiring for calibration.
Hi i m B.E. In elect. & comm. I m workin in bio mass plant from 6 mnths as inst. Engg. but now i m in dept. Of operation as shift engg...which is best operation or inst. 4 me? M confusd..plz help and reply me..
i want to find out iffco get test paper
the pump holds on run indication into the dcs and filed local control panel remote push button condition operaton wrong like when the push button pushing conditions the pump is off and the push button release condition the pump is on totally opposite condition . And control room inside give the stop command into dcs just 1secon relay engage and again normal condition. How can I slove
Why is the orifice tab provided?
the whole paper was based on Transducers..questions like define repeatability, error,accuracy,precision..den there were many q. on the conversion of Pa to mmHg and other units.. also..der wer few Q. on some level sensors(with diagram)
What types of Instrumentation Related Questions can an Interviewer ask in a Telephonic Interview ?
can we replace a slot sensor (inductive type) with limit switch (potenial free contact / no-nc type).
