Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / soumik kar
a two phase motor is a motor with the the starting winding and the running winding have a phase split.
e.g;ac servo motor.where the auxiliary winding and the control winding have a phase split of 90 degree.
| Is This Answer Correct ? | 11 Yes | 0 No |
Post New Answer View All Answers
Difference between rating factor of cable and derating factor of cable?
What are the advantages and disadvantages of negative feed back?
What is the earth treantment procedure?
can we use ZNyn11 transformer instead of Dyn11 transformer in distribution for effectively eliminating harmonics from the industrial loads.
What is the implications when 600 hp motor is started when the unit is running with Transformer of capacity 1500 KVA and DG set of 1000kva
Two electric lamps 40 W, 220 V each are connected in series across 220 V. What is the power consumed by the connection?
What is the function of retrip in busbar?
Define noise?
What is the formula to calculate a three phase alternator
sir, i'm preparing for hpcl exam officer trainee pls tell me how the exam ques paper pls pls
Saving in copper achieved by converting a 2 winding transformer in to an auto transformer is determined by A voltage transformation ratio B load on secondary C quality of core material D size of transformer core
need to make a report. Need to choose a 3phase induction motor. Load conditions motor will operate in : Maximum Load: 30 Kw Speed: 2950 rpm Ambient temp: 20 cent Supply voltage: 440V Frequency: 50Hz need to look for the safety factor when choosing the motor, went through catalouge found a few, but dont know how to choose the safety factor allowing an extra load something above 30 KW to avoid any harm.
My question is whether bellow formula is correct to find bus size for 46kA for 0.5 second & what is RT in bellow formula. formula to calculate the size of busbar to withstand the thermal stresses due to currents with duration of 0.2 sec to 5 sec. Sp = RT( I x I x t) / K Where Sp – is the cross sectional area of bus bar in millimeters. I - is the value of AC fault current. t - is the operating time of disconnecting device in seconds. K – is the factor depending on the material of the conductor, insulation and initial and final temperature. Value of ‘k’ for copper is 143.
if sf6 gas low in gis what will happen
How i can decide that HVDC line is best for transmission.
