1 bar is equal to how many pound per square inch(psi)?
- 14 Answers
- 42476 Views
- Essar, I also Faced
- E-Mail Answers
Answer Posted / tauqeer
1 bar = 14.5 psi
| Is This Answer Correct ? | 65 Yes | 14 No |
Post New Answer View All Answers
send me last 5 years questions asked in rrb chennai, for section engineer
sir, i preparing hpcl,ongc,barc,hal exams(instrumentation engg)pls send a placement papers
Can any body help to get Rsemulator 5000 free from internet if possible then give me any link or any help .
any body who gone thru recent iocl interview.INSTRUMENTATION questions. I need.
where cascade loop use ?
please send me some question papers of HPCL aptitude test ?? please send it to bipinb.28@gmail.com ...
hi i am eswar i want to know the instrumentation interview questations for eil(engineers india ltd) i have applied for engineer post in eil please help in this.my mail id eswar310@gmail.com
Can any one tell me what type of question asked for instrumentation and control interview panel??? pls mail ramashankar.goel@gmail.com
What is the Working principle of Dozing valve?
hye SAM acn u send your e mail id, so that i can solve my query through e mail?
give me all the details about the interview and which type of question being asked
please tell no. & add. of consultancy who recruit me in power plant as instrumen engg. present i m working in power plant as ass.t instrument engg. thanku mahesh 09226562826
A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.
can any one tell me when ongc placement test and its forms is available????/ pls tell me if u know
hello friends, can you please send me the model paper or question paper to be prepared for hpcl examinations????????? You can mail me at rahim_here@yahoo.com waiting for your reply........... help me .. plz.....
