Interested to Buy Any Domain ? << Click Here >> for more details...
In CDG type IDMTL realy O/L , E/F, O/C which are used for
out going feedrs,on R-phase o/c element, Y-phase , e/f
elecment and on b -phase o/c element will be connected .
Why the earth fault on center phase only, why not on other
two phases?
- 2 Answers
- 9429 Views
- I also Faced
- E-Mail Answers
Answer Posted / gova
This is called 2 O/C+1E/F relay scheme.This scheme is used
mainly where the transformer connection is Dyn11.
please refer the current distribution in this transformer
when a fault occurs in feeder.
This scheme will be sufficient to clear the faulty
section.But nowdays 3O/C+1 E/F relay scheme also used in
many places
gova
| Is This Answer Correct ? | 6 Yes | 2 No |
Post New Answer View All Answers
Ac generato how produce power I need for camplet defination
How do u analyse protection fault when vcb tripping on load
why zero sequence impedance measurement is not applicable for single phase GT
In general bus riser follows the bus section in SWGR. What are impacts if bus section follows bus riser?
defination of lines
what does mean of RCT and STR in diffrential CT?
what is an unbalance in acircuit? in a three phase 3wire circuit how an unbalance will come? in a three phase four wire system how an un balance is coming?
how to calculate the power factor when instantaneous voltage and current has harmonics in it ?
how to copy from plc ge fanuc versamax series,all input and output, adress, and printout.
What are the advantages of the three-phase motor over single phase motor?
Why the output of OP-AMP is always less than Vcc?
Hi Suppose we have a wye/wye transformer which is grounded at both sides,in this situation, do we have ay ground transformer? in other words, ground transformer can do any thing more (while we have nuetral wire in both sides)? As the last question, what about 3rd harmonic? we have two choices: first using wye/delta transformer + ground transformer and second using wye/wye earthed connection.in the former choice, we dont have 3rd harmoonic at the secondary side but what about Yn/yn conection? do we suffer from 3rd harmonic in the Yn/yn connection?
Vibromotor 252MV 1/4HP2P..what is mean by 252MV?
Starting current of a 10 HP induction Motor is ______ time’s full load current.
Define unilateral circuit?
