Interested to Buy Any Domain ? << Click Here >> for more details...
TO operate transformers in parallel, vector symbol of the
both should be same.If one transformer name plate is not
there, how can we conclude that whether the transformer is
having the same vector symbol or not?
- 4 Answers
- 7643 Views
- I also Faced
- E-Mail Answers
Answer Posted / rajendran
we can easily find out and confirm the vector group of the
transformer by using the standard test procedures.
| Is This Answer Correct ? | 3 Yes | 3 No |
Post New Answer View All Answers
What is main cause of cable's terminal point burned in Lug on high temperature although lug and cable selection is ok as per stantard and also tightness is ok as per situation. so please take in deep and tell correct answer thanku.
The efficiency of a 100kva transformer is 0.98 at full load as well as half load , for this transformer what is the Copper loss at full load ?
What is Bolted fault?
how u select control transformer for a mccb panels or any panels?for expample we hav 440 volts maim supply and control volts is 230v?
why voltage form factor of PT are increase , when it is ecpected heigher spikes in system. how it is calculated.
how is the cable tray designed & how its total length is calculated for an Industrial plant Say for Ex. (500KW Motor Load)
How you give clearance to a spare feeder.
Good day everyone,currently in our premise we using 30kw slip ring motor with resistance bank which we use as forward and reverse at conveyor bar handling. So,my question is how do we calculate the resistance bank which is suit the motor. Kindly,assist me... thank you
what is the working process of over & under voltage relay.
what are the parameters plays a major role in Potential transformer Burden calculation??
What is the cut-off rate?
why asa method ZPF method is more accurate than ASA method?
I have a drawing of a wound rotor induction motor for a crane. This crane motor has 5 forward speeds & 5 reverse speed implemented of course with different amount of resistance for each speed setting selected. What has got me scratching around is the fact that 8 of the 10 speed selections switch in uneven (unbalanced) amounts of resistances on each of the 3 connections to the motor's rotor.Can this be possible? I would have assumed this would produce unbalanced rotor currents and therefore vibration in the motor. I would greatly appreciate anyone's comments on this. Many thanks, Confused.
Which standard we are following earthing resistance test
What is reverse power relay?
