Interested to Buy Any Domain ? << Click Here >> for more details...
what is diff between the centrifugal and reciprocating
- 2 Answers
- 6131 Views
- I also Faced
- E-Mail Answers
Answer Posted / h.s. patel
In centrifugal, kinetic energy is converted to potential
energy by rotary motion.
In reciprocationg, energy is given to pistion for axial
movementin piston cylinder. Volume equal to piston movent
is displaced in each stroke of pisto.
| Is This Answer Correct ? | 5 Yes | 1 No |
Post New Answer View All Answers
What is offset in a control system.
What care will you take in the installation of control valves,SCADA,DCS and FOC in Oil and Gas Project?
why any measurement made interms of pressure is more accurate ? to be more precise most of the flow velocity is made interms of pressure and it is accurate. what is the reason behind pressure measurement being accurate ?
what is sliding spool valves?
If fire would be inside the plant which fire detector is to detected the fire.
Full form of KKS when use DCS.
How to Calibrate Interface Level Troll in field
what is the difference between profibus and controlnet networking.
What are the interlocks we have to check during the start up of LP/HP compressor?
kindly sent some demo question and answer
principle of automatic votage regulator
Which are all the commonly used Bordon tubes in the pressure gauges. Do any one use ASTM A 312 tubes for this purpose?
Tell me the field calibration procedure step by step with diagram of pressure gauge, pressure switch, pressure transmitter, temperature switch, level switch, flow switch, flow transmitter.
PT RTD Range: -200 to 500 degree celsius If I configured in DCS Lower range and Upper range . In face plate it shows red colour due to overa range how was the characteristics look If the temperature is more than operating range. how was the characteristics look . whether its in Resistance vs Temperature curve is Linear or Non linear
Explain why plc require in analog input 4-20amp & 0-10 volt?
