Interested to Buy Any Domain ? << Click Here >> for more details...
What is the difference between CRNO and CRGO in an
transformer and what is the advantages of these two.
- 13 Answers
- 74279 Views
- Anchor, CIL, ETA, Kirloskar, I also Faced
- E-Mail Answers
Answer Posted / rameez raja kaleel
The correct explanation is for cold rolled grain oriented
winding have the flux density is saturated.we know the flux
density B= flux/area since Bis constant the flux is also
constant there will not be any change in the frequency
since E/F is directly propotional to flux hence the losses
in the windings has been reduced,.but i have no idea on CRNO
| Is This Answer Correct ? | 10 Yes | 12 No |
Post New Answer View All Answers
1. The DC generaror,s induced output emf is connected with a DC motor(as load). when increasing the load of the motor by using brake drum or any way. what are the parameters will changes in both motor and generator(voltage, current, resistance, frequency, speed, torque, power, flux etc...) 2. Similarly for AC generator and AC motor 3. similarly if using DC batteries instead of DC generator, What happens?
I HAVE A INCOMING 100A MCCB TPN 25KA, CABLE LENGHT OF 80M 70MM CABLE SIZE FROM MAIN SUBBOARD TO NEW DB.BASE ON THE FAULT LEVEL SETTING OF 45KA.I WOULD LIKE TO FIND OUT 25KA ENOUGH KA. APPRECIATE IF SOMEBODY CAN ASSIST ME WITH FORMULA FOR THIS. FRM: JEFF
What is meant by rotor?
Is there any rule to select the voltage of motor based on KW rating? What is the rating above which lt motor becomes the HT motor?.
How to select cable the size, what is the parameters use and what is the formulas use for this cable size calculation?
how synchronous condenser is used in place of synchronous generator with out negotiating IEEE standards? Can i use 3 generators as synchronous generators and 2 generators as a synchronous condensers in an IEEE 14 bus system with out disturbing the standards?
what will happen if frequency is below 50 hz?
what is the diff. between x'mer , isolation x'mer & ultra-isolation x'mer ?????????????
Dear sir, How to calculate 3.5 core pvc aluminium armoured cable meter wise carrying amps rating.Please give the solution with a good example.
How does the slip regulator works as a startor
Define load factor?
Is any generator is developed which is operated with out diesal or other expensive source?
Why are the laminations insulated from each other?
can the measured percentage error during calibration of single phase energy meter be negative?
why current is constant on d.c?
