Answer Posted / silamparasan p.
Fuse is used to limit overcurrent. So we have to use fuse
in phase only.
Neutal is for pass, if any faulty current or unbalanced
current. We dont know how much Ampere current flows through
the neutral during any fault or unbalance, it may be high
current also. If we use fuse in neutral during faulty
current the fuse in neutral will blown and it will camage
the unbalanced power system. And it will damage yje
components.
| Is This Answer Correct ? | 33 Yes | 3 No |
Post New Answer View All Answers
I am getting above 60 V as open delta voltage against single phase unit ICT at tertiary delta formed and ICT getting trippped on NDR. ICT tested and found in order. PTs provided on tertiary are tested and in order. what may be the reason?
what is the meaning of number in (11, 31, 61,14, etc. CDG11, CDG31, CDG61, DDT32
In India the supply voltage is 230 volt A.C. During the negative half cycle phase becomes neutral and neutral become phase? or what will happen during negative half cycle? how the electrons flow during positive and negative half cycle?
If there are two transformer having rating of 2.5mva, 6.6kv/440v(satr-star),and the load is 600kw then what is better to maintain less losses in transformer having both transformer in parellel or only single transformer connected to load? Please give calculated answer
how can we change the phase angle b/w two phase?
How you will determine the volume of oil in a particular Distribution transformer.
what is the synchronous timer ? and it applications.
How many kinds of E.L.C.B and how to work E.L.C.B
What is meant by harmonic distortion?
physical identification of HT & LT panel
what is the importance of Partial Dischage test for Electrical Equipments
What difference between ref protection and differential protection ?
how to decide choke rating for drive?
In aerodynamic turbines which element is NOT there a.stator b.compressor c. Fuel intake system d.fans
what is transistors comprised of?